Sachets
Anabolic Steroids packed in Sachets are a new product-line in our stock. Sachet packed Anabolic Steroids are unique in many regards as they are considered to be the future of Mail order Steroids.
As most Athletes know the packing is more than merely something that holds oil - if the packing is incorrect, the contents can go sour before they actually get to the final destination. The paper of the sachet is made of many different layers and protects the contents from all outer elements and it meets the highest medical standards. The packing, as long as it's factory sealed, is as good as a glass vial.
Anabolic Steroid Sachets are sold as 3 ml units - however, the sachet actually contains 3.5 ml - We are selling it as 3 ml because we believe our customers will be able to inject at least 3 ml of Steroid out of every sachet (every time some oil remains in the syringe, the sachet.... However, if an Athlete is careful and drains the sachet completely, he actually gets 0.5 ml for free.
The sachets are designed in such a way as to pass any inspection without raising any suspicion. There are no obvious markings on the sachets themselves that would imply the contents - a casual observer would think that the sachet contains some kind of massage oil or other.
A sachet is approximately 2’ by 2’, and not more than 1/4' thick - when shipped by mail it is as suspicious as a postcard.
The only markings that actually identify the contents are on the back side of the sachet - each sachet has an imprinted production date in eight digits like 13.05.2006. followed by 2 or 3 letter code that identifies the product, for example BU represents Boldenone Undecylenate. So the whole code is like this 13.05.2006.BU
Sachet identification codes
Here you can see the whole Anabolic Steroid Sachet production line and the corresponding codes:
- Nandrolone Decanoate 250mg/ml – Code: ND
- Testosterone Cypionate 200mg/ml – Code: TEC
- Testosterone Propionate 100mg/ml – Code:TEP
- Testosterone Enanthate 250mg/ml – Code: TEE
- Boldenone Undeclynate 200mg/ml – Code: BU
- Trenbolone acetate 75mg/ml – Code: TRA
- Primobolan - Meteneolone Enanthate 100mg/ml – Code: ME
- Dromastolone Propionate 100mg/ml – Code: DP
- Sustanon 300mg/ml – Code: TE3
- Trenbolone Enanthate 100mg – Code: TRE
- Nandrolone Undeclyanate 200mg – Code: NU
- Nandrolone Mix (150mg nandrolone decanoate + nandrolone phenylpropionate 50mg/ml+ 100mg nandolone undeclayante) – Code: ND3
All of the products are of extremely high quality, produced pharmacy grade and the contents of the active Anabolic Steroid is up to a mg correct.
Extracting sachets contents
The easiest way of taking out the steroid is to take it out as of a vial:
- Before actually drawing out the steroid it's a good idea to worm it up somewhat as the oil is less dense when warm - place it over a hot cup of water and the steam will heat it up in half a minute - don't actually put it in water as you might heat it up too much.
- Place a needle on a syringe and pierce the corner of the Sachet - only pierce a quarter of an inch deep, and make sure you pierce it at a right angle or the needle will get out on the other side.
- Start drawing the plunger immediately or the oil could drip out at the sides.
- You need to drain the sachet completely - you can't keep the Anabolic inside once you've opened it.
- If you don't intend to use the whole 3 ml in one shot you can drain the sachet completely and then inject it to a multi-dose vial, and store it for further use. If you don't have a vial at hand, you can also store it in the syringe for couple of days (replace the needle immediately after the shot and put a fresh needle on; keep the syringe in a dry and dark place at room temperature.).
